NHTSA complaint #11764777

Owner complaint summary

I bought this used truck with 60K miles on it in 2024. It is a 2020 truck. At 136K the engine failed.........with the infamous [XXX]. I have an excel summary spread sheet on all maintenance I had done since I owned this truck and I did not pull or haul anything. I heard a tick for about 10 days before I took it to my dealer whom I bought it from and they stated after "scoping" that the # 8 cylinder misfired and cylinder wall scored and the lifter pin bearing failed thus cam shaft damaged and exhaust manifold cracked. They had to replace the engine with a remanufactured engine from [XXX] and replaced intake and exhaust Manifold at a cost of $ 15,021 out of my pocket. I was stuck with no options logically. I do not have a problem with the Dealership - [XXX]. I have a problem with Ram Engineering, Stalantis design. To me there is no excuse to have a big cast iron block v-8 fail at 136K miles. There are many more ram owners who have this same problem I just stated that I had. If I knew then what I know now i would have never bought this truck with this 5.7L engine. There were no warnings, messages or anything displayed to alert there was a problem. I expect that there was not enough oil flow to # 8 cylinder ( which is all the way back to the left rear ( passenger side) of the engine ) looking from the front of the truck as I read many Ram forums on line. I changed to oil every 5K miles with Mobil 1 full synthetic oil along with the filter - either Mobil 1 or WIX filters. some of the best on the market. I do not know what I can do now but this is rediculous. I won't get burned again. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)