NHTSA complaint #11765186

Owner complaint summary

Since the 68C Jeep Wrangler recall was applied to my vehicle this past July, it has been exhibiting erratic behavior during acceleration. At varying times, when the accelerator is pressed from a stop, the vehicle will begin accelerating at normal rate, but then suddenly the power will drop off, resulting in the acceleration rate being dropped to where the car is barely accelerating. For instance, I was making a left hand turn from a stop, and when I accelerated onto the road, my speed quickly rose to 20 mph, but then the vehicle stopped accelerating, and remained at 20 mph. At the time, the vehicle was operating on battery power only. I immediately began increasing my throttle input, but the car failed to increase acceleration. Only once I had the pedal to the floor for a few seconds did the internal combustion engine activate, allowing the car to begin accelerating again, albeit at a slow rate that was not commensurate with the throttle position. This event has almost resulted in other vehicles colliding with my car when I was attempting to enter a busy road. This has occurred on a number of occasions, and the fact that this happens randomly presents an extremely dangerous situation that is not predictable. Other people who own the same Jeep Wrangler 4xe platform as me have also reported this occurring to their vehicles. Jeep, however, has not responded to this alarming problem, and simply has been telling customers who call Jeep customer service or take their vehicles to a dealer that there is nothing wrong, and the vehicles are operating normally. This is not acceptable, and with tens of thousands of these vehicles on the road, presents a significant danger to the owners and public at large. For the record, there were no warning lamps, messages, or any other symptoms prior to each incident for me. It also has occurred no matter the current capacity of the battery.