Verified government source

SaferProducts incident

Official U.S. Consumer Product Safety Commission consumer incident report from the SaferProducts.gov public database. Use the verification links below to confirm the record on SaferProducts.gov or via the public database export.

Product

Bosch Dishwasher SHX7ER55UC-44

Category

Kitchen Appliance

Report number

20170505-AA9C8-2147403733

Ownership age

Not stated

Failure type

Fire / ignition

Incident narrative

SaferProducts.gov consumer incident report 20170505-AA9C8-2147403733. Severity: Incident, No Injury. Product: Bosch SHX7ER55UC-44 (Bosch SHX7ER55UC/44 dishwasher, S/N 9109, P/C 00581). Incident: I have a Bosch SHX7ER55UC/44 dishwasher, S/N 9109, P/C 00581. The unit was subject to a recall for the power cord, and Bosch previously sent a technician (from Mr. Appliance, Epping NH, �[REDACTED]�) out to replace the cord set (on 8 December 2015). The technician applied a green "R" sticker on the top edge of the door and on the cover of the junction box. The (no cost) invoice stated �Replaced power cord kit per Bosch recall unit tested ok� and under material listed the part �Power Cord - 12010137 � BSH�. The unit had been working without issue since. This morning (5 May 2017) it was noticed that dishes were wet, and the unit had not fully drained from a cycle started last night. It was then noticed that the unit would not turn on. This evening, I pulled the unit out from under the counter, unplugged the power cord from the unit, and checked for voltage. There was 123V from the hot to ground, but only 3V from the hot to neutral. I turned off the circuit breaker, and opened the power cord junction box. The terminal in the power cord junction box (which the Bosch-authorized Mr Appliance technician had previously worked on) had clear evidence of overheating. The insulation was melted off the neutral on the line side, part of the plastic terminal was melted, there was char inside the box, and odor of electrical fire. While the hot and ground were firmly attached, the neutral on the line side had some play in what was left of the terminal. Had the wire not loosened enough to create the power loss to the unit, a catastrophic fire could have resulted.

This is a consumer incident report published on SaferProducts.gov. CPSC does not guarantee the accuracy of information submitted by people outside of CPSC. It is not automatically an official recall or manufacturer admission.

Official report number: 20170505-AA9C8-2147403733. Search that ID on SaferProducts.gov or match it in the CPSC public database export to verify this record.