Verified government source

SaferProducts incident

Official U.S. Consumer Product Safety Commission consumer incident report from the SaferProducts.gov public database. Use the verification links below to confirm the record on SaferProducts.gov or via the public database export.

Product

DeWalt Model DXPW3324I

Category

Kitchen Appliance

Report number

20230615-0AFAA-2147346984

Ownership age

About 11 months to failure (from purchase date when reported)

Failure type

Electrical shock / short

Incident narrative

SaferProducts.gov consumer incident report 20230615-0AFAA-2147346984. Severity: Injury, Emergency Department Treatment Received. Product: DeWalt Model DXPW3324I (DeWalt Pressure Washer, Model DXPW3324I). Incident: In July 2022, I purchased a new DeWalt pressure washer at The Home Depot. I'm quite familiar with using pressure washers as I have used several in the past 35 years. This new pressure washer was working fine as I cleaned the siding on my house. I noticed the engine starting to sputter so I shut the machine off to refill the gas tank. Once refilled, I grabbed the starting cord handle and gave it a pull. Because the starting cord is angled slightly toward the front of the machine, my pulling of it caused the entire machine to lunge forward. What I assume is the hot metal muffler in the front of the machine momentarily came into contact with my left leg and I immediately felt the my leg burning and it turned red. The next day, I had a rectangle-shaped burn mark on my leg with blister bubbles and oozing burns. With the burn being painful, oozing, and blistered, I decided to visit my local Emergency Room. The ER doctor and nurse prescibed medication to apply to the wound and indicated that I had a partial-thickness burn. As it was rather grotesque and somewhat painful, I covered the wound when wearing shorts for the remainder of the summer. Nearly a year later, the scar on my leg is still present and I'm assuming will be there for life. I consider the design of this pressure washer, with the starting cord angled towards the front of the machine, along with its light weight, to be a design flaw. It would have been just as easy for the manufacturer to NOT have the starter cord angled toward the front of the machine. Rather, it should be angled directly to the side of the machine s

This is a consumer incident report published on SaferProducts.gov. CPSC does not guarantee the accuracy of information submitted by people outside of CPSC. It is not automatically an official recall or manufacturer admission.

Official report number: 20230615-0AFAA-2147346984. Search that ID on SaferProducts.gov or match it in the CPSC public database export to verify this record.