Ram 2500 2019

Tl* the contact owns a 2019 RAM 2500. While driving 65 MPH, the rpms increased and the engine revved. The contact released the accelerator pedal and manually shifted the gears in order to return to the correct reading. In addition, the computer system that controlled the radio and camera would glitch and hesitated to change views. Also, while driving approximately 40 MPH in an intersection, the vehicle suddenly accelerated, despite depressing the brake pedal. The contact stated that the ignition and check engine warning indicators illuminated. The contact was able to pull the vehicle over to the side of the road and shifted into park; however, the vehicle continued to rev as if the accelerator pedal were depressed. When the contact turned off and restarted the vehicle, all the warning indicators illuminated and the vehicle stalled. The vehicle was towed to crown motors (located at 555 cypress ave, redding, ca 96001, 888-755-5922) where it was diagnosed that the EGR valve closed and needed to be replaced. The vehicle was repaired. While driving 45 MPH uphill, the vehicle stalled without warning. The contact was able to pull the vehicle over to the side of the road where it came to a rolling stop. The contact stated that the accelerator and brake pedals failed. The contact had the vehicle towed to the same dealer to be diagnosed, but no codes were found. The vehicle was not repaired. The manufacturer was made aware of the failures and provided case number: 64570388. The approximate failure mileage was 300.

On June 26, 2024 during a long road trip, the vehicle lost power repeatedly in the middle of an area with no road service. It put my safety and that of my passenger at risk on the highway as losing power suddenly causes danger in fast-moving traffic causing the risk of potential collisions with other vehicles. There was no warning lamp indicating the failure would occur. To this date, the dealer has not fixed the issue. After approximately three weeks, I picked up the vehicle after it as allegedly repaired (at that time the dealer stated it was an electrical issue). The vehicle failed again not more than one-half mile from the Omak Dodge service center placing my safety at risk yet again. I managed to get the vehicle back to the service center at which time, the dealer stated after consultation with RAM technical support, that the issue was a failure in the fuel system. The dealer claims that the problem was the failure of a fuel injector/pump that caused particulate matter to contaminate the entire fuel system. Being that it was allegedly a power train failure, it was to have been covered under the power train warranty. After approximately three months of delay, the dealer stated the truck was repaired. On arriving at the dealer to pick up the truck, the dealer stated it wasn't repaired and had an exhaust issue. The truck remains at the dealer to this date, October 25, 2024. The dealer states that the exhaust issue is yet another issue with the truck that is covered under a warranty voluntarily extended to 10 years by RAM.

We took a trip from Daleville, Alabama to Las Vegas, Nevada. Before we left, We took my 2019 RAM 2500 Bighorn diesel pickup to our local Ram dealership, Mitchel Chrysler Dodge in Enterprise, Alabama to have it inspected, to make sure there wouldn't be any problems along the way. They cleared it, and said there was nothing wrong with the vehicle. On my way, the steering wheel position started slipping to the left. after that, I received a waning on my dash that said " electronic stability control". So I took it to the closest RAM dealership, in Lawton Oklahoma, and they stated "needs a steering Gearbox replacement" and it would take two weeks to get the part, and then fix it. They told me it would be safe to drive. When I got to Las Vegas, at that point it was at the seven O'clock position. We took it to Chapman RAM dealership and they told me it was a loose jam nut and it had stripped the drag link. During the diagnosis they broke they clockspring on the air bag. They quoted that to fix the vehicle it would cost over three thousand dollars! They said it would not be covered on my mopar extended warranty. So I began researching it and found the recall- V06/NHTSA 19V-021 drag link for 2017-2018 (DJ) RAM 2500 pickup. My RAM was built in June of 2019. How can this still be a problem 6 months later after the recall ended? My safety and the safety of others could have been compromised if the drag link would have completely pulled out. I could have lost control of the vehicle and it could have caused a serious crash ending in injury or death to myself, and others.

We bought our truck in November 22, 2022, used certified pre-owned with 22135 miles, On 12/27/2022 message code came on water in fuel tank. 12/29/2022 dealership service helped us to drain fuel filters and cleared the code. 12/30/2022 same code came back. 1/8/2023. Truck broke down with a major total fuel system damaged. Parts were ordered, but repairs did not start yet. Everyone is trying to say it is a user error. We refilled DEF liquid correctly after which the gage showed was almost full. Dealership was blaming bad diesel was used, but as a consumer how in the world will i know which brand or company: they all are governed to sell proper diesel. We only drove about 3000 miles. There's no way possible for such to happen. Dealership told us ok to drive and keep refilling fresh diesel. We learned that there was already a recall for fuel system back in September of 2022. Supposedly if diligently and correctly it was taken care of, this same problem should have not come back at least for the next 10000+ miles. We only put on about 3000 miles from the date of purchase. Also according to inspection of dealership and service history, they also replaced fuel filters in October of 2022. Truck broke down even before our first payment was to be due. Currently our truck is not drivable and we are in 7 yrs loan. Absolutely ridiculous. There must of been a hidden tank leak that caused fuel contamination. Dealership where our truck is confirmed DEF liquid was mixed with diesel gas and a corrosion around some parts. Please help us! This is a nightmare. Thank you so much in advance!

Continuation to NHTSA ID # 11511305 Adding some more details and photos of the Fire. (2019 Ram 2500 6.7L Cummins Diesel engine) This is to describe the time frame from the start of the vehicle to when the fire department put out the fire. I have a store receipt that time stamps my checkout time at 2:11p CT, from the time I left the store, loaded my purchases into the truck, started and drove the car a very short distance, when the smoke started to pour out of the inside ventilation system, I pulled the truck over to the side of the road, got out of the truck and called 911 (time stamped from my phone was 2:29p CT. (18 minutes from checkout to 911 call. I Took a picture of the truck after the fire department put out the fire (time stamped 2:38p CT (9 minutes from the start of the 911 call). Adding some pictures of the burnt-out truck. What shows is that the fender on the driver’s side took the brunt of the heat, where all the electrical systems reside. Telling me that this was the main section that started on fire (possibility that the Heater Grid). This was definitely an electrical fire, given the smell and smoke that poured into the truck. I know there is a current recall by the auto maker. I think they should re-evaluate they years that this recall should affect, since my 2019 has the same parts used as the 2021-2023’s. Given the pictures below and the disaster that this caused, we were pretty lucky that it was just me and my wife in the vehicle. We were able to find a spot to pull over so it wouldn’t affect other traffic. What if we were stuck on a highway, in traffic, pulling a trailer in a rural area, who knows what else could have happened. The stress of this is overwhelming, something that I will relive over and over again. Photos and Fire Report attached.

What component or system failed or malfunctioned, and is it available for inspection upon request?: The right-side tailgate hinge assembly on my 2019 Ram 2500 failed and became increasingly difficult to operate. The tailgate now requires excessive force to open and close throughout its entire range of motion. An independent body shop inspected the vehicle and determined that the hinge assembly requires replacement. The vehicle and failed component are available for inspection upon request. How was your safety or the safety of others put at risk? The failure significantly affects the normal operation of the tailgate and requires excessive force to open and close. This creates a risk of injury while operating the tailgate and raises concerns regarding the continued safe operation of the tailgate assembly. The failure of a primary tailgate support component could also affect the tailgate's ability to function as intended. Has the problem been reproduced or confirmed by a dealer or independent service center? Yes. The problem was inspected and confirmed by an independent body shop. The shop determined that the tailgate hinge assembly has failed and requires replacement. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives, or others? The vehicle has been inspected by an independent body shop. At this time, the vehicle has not been inspected by the manufacturer, police, or insurance representatives. Were there any warning lamps, messages, or other symptoms of the problem prior to the failure, and when did they first appear? No warning lamps, messages, or diagnostic indicators were present. The only symptom was a progressive increase in the force required to open and close the tailgate. I started to notice the issue about a year ago. Since then, the condition gradually worsened over time to the point where when I open it and the tailgate pops out of position.

The truck was initially brought in on April 10, 2024, for a continuous regeneration issue with the DPF filter, showing codes P242F and P1451. The dealership diagnosed it as requiring a new EGR valve and possibly a DPF filter assembly, under the VB6 emissions recall and extended warranty (XQ1). After replacing the EGR valve, the Y-78 HPFP safety recall was completed. Upon completion, the technician noted multiple fuel-related DTCs, lack of power, and metal debris at the fuel control actuator caused by a failed CP4 pump. At this time, the dealership was unaware of the XQ1 warranty, so instead of replacing the DPF filter, they force regenerated it. Upon picking up the truck, the check engine light came on (April 26, 2024). After reporting it, the dealership stated the DPF filter needed replacement, and on May 26, 2024, it was replaced under XQ1. However, after picking up the truck again, the check engine light came back on, and diagnostics revealed misfires across all six cylinders (codes P0300–P0306) and abnormally high fuel pressure at the wire harness—issues that weren't present before the EGR valve or HPFP recall repairs. The truck has since remained at the dealership, with multiple unsuccessful attempts to fix the issue by replacing the fuel lifter, wire harness, fuel filter, and a second Y-78 recall replacement due to "faulty parts" from the first attempt. The dealership charged a diagnostic fee and suggested replacing rocker arms and push rods, but this did not resolve the problem. The dealership has since recommended replacing the PCM module but then retracted the recommendation and is now requesting a new diagnostic fee to tear down the engine, remove cylinder heads, and inspect for debris, as the misfires and high fuel pressure have persisted since April 26. The safety concern is that the truck behaves as though it is starving for fuel when the engine light reappears, with stored codes showing misfires and high fuel pressure, related to Y-78.

In August 2020, while I was driving my vehicle at approximately 15 mph, with approximately 13,500 miles on the odometer, I noticed that the vehicle's transmission gauge was about 230-240 degrees. I pulled over and smelled smoke. Luckily, my passengers and I were able to get out of the vehicle. The vehicle was completely destroyed. I have video showing flames coming out of the passenger side engine compartment. I had previously taken my vehicle in for repair for recall W03 to have the transmission valve body replaced so the transmission wouldn't cause an engine fire. FCA had an expert inspect the vehicle and he found that "fire progression appears to be from engine compartment thru entire vehicle terminating at rear truck bed," that "possible source of ignition is hot surface of turbocharger/exhaust components. - Most likely method of ignition is transmission fluid expelled from dipstick tube," "origin appears to be in the engine compartment," and "possible cause appears to be transmission fluid expelled from dipstick tube onto turbocharger/exhaust components. The determination of possible cause is based on: 1. Owner/driver's description of events. 2. Transmission of dipstick is extended ~ 27.0 inch from the fill tube." Despite this, FCA refused to pay me for my destroyed vehicle (or the trailer that it destroyed) because: "After the inspection of your vehicle, the information at hand would not permit us to associate the fire with a manufacturing or assembly error. We are sure you will understand fires of this nature can and do occur for a number of reasons not associated with the manufacturing process. Therefore, we must respectfully decline any assistance associated with this matter. Based on this, we suggest that you refer this matter to your insurance carrier . . ." I already had the transmission fire recall performed and my truck still blew up. Luckily, I was not injured. I am worried that if FCA does not do another recall, other trucks will blow up too.

Following completion of the Y78 (high-pressure fuel pump) and XQ1 (emissions) recall repairs in April 2024, our 2019 Ram 2500 immediately began experiencing misfires, fuel system issues, and ongoing performance problems. These symptoms have persisted for over a year and have never been resolved despite repeated service visits and escalations. The vehicle suffered multiple HPFP failures, including one that caused fuel to leak into the crankcase, resulting in approximately 19 quarts of fuel-contaminated engine oil. Despite technical service bulletins calling for specific system flushes and tests post-repair, the original dealership did not follow these protocols or provide documentation confirming that the required inspections (fuel pressure, contamination checks, EGR/DPF/DEF system functionality) were ever completed. A new dealership confirmed the presence of metal debris after the fuel filter, suggesting the system was still contaminated even after the prior recall-related flush and HPFP replacements. They also found non-functional emissions components covered under XQ1, including a failed DPF urea pump and a faulty NASA pressure sensor. These failures were not documented or addressed by the original repair facility. Despite these clear safety risks, the recall is considered “completed,” leaving us with a vehicle that is still experiencing symptoms consistent with the original recall condition. The failure to properly inspect, document, and address these defects has placed our safety at risk and caused prolonged loss of vehicle use. The issue, confirmed by a 2nd authorized dealership, identified fuel contamination & failure in multiple components of the emissions systems. The check engine light appeared prior to the initial failure and has recurred each time the vehicle was returned after service. Given the continued presence of recall-related symptoms and the lack of proper inspection & documentation, this unresolved recall should be reopened and investigated