Belt drive / controller fault
Drive motor / controller board
Source-linkedVerify source — Reddit postProForm 500 incline and display still worked but the belt would not move unless pushed by hand; manually moving it started the motor with an electric burning smell while the controller LED went from solid to blinking red. About 1.5 years earlier a similar no-start issue was fixed by replacing the controller; this time there was no whirring sound on button press.
UnverifiedEvidence ★★★☆☆View report detailsHide report details
Belt drive / controller fault
Drive motor / controller board
Months until failure
Not stated
Repair cost
Not stated
Repaired
No
Manufacturer warranty
Not stated
Extended warranty
Not stated
Support helpful
Not stated
Would recommend
No
AI extraction confidence
88%
Verification status
Unverified
Evidence quality
★★★☆☆ (3/5)