Product image pending

We track images separately from defect reports.

Home & Garden

Rheem Performance Platinum XG50T12HE40U0

1 source-linked failure report. Most reported: Overheating. Typical failure around 1 mo.

Reliability signal — · Insufficient data · data confidence Very Low

1 confirmed failure reports

Reliability summary

What is likely to go wrong, when it happens, and how expensive it can be — from source-linked failure reports. Counts are reports in our database, not a population failure rate. Methodology →

Reliability signal

—

1 confirmed failure report · Insufficient data · Data confidence: Very Low

Need at least 5 confirmed failure-signal reports before showing an A–F grade.

Most common issue
Overheating
Typical first failure
1 mo
Median of confirmed reports with timing
Median repair cost
—
Reported costs only · market varies
Highest reported repair
—
Not a quote · costs differ by country

What breaks?

Failure types

Click a type in the reports section below to filter.

  • Overheating1 · 100%

When does it break?

Failure timing

Months after purchase, using reports that included timing.

What does it cost?

Reported repair costs

Distribution of owner-reported repair costs— not a quote or guarantee. Labor and parts prices vary by country.

No reported repair costs yet for this model.

Median months to failure

1

Failure reports

1

View →

Median repair cost

—

Still recommend

—

% repaired

—

% mfr warranty

—

% extended warranty

—

% support helpful

—

Use these reports as a risk signal, then check current listings before you buy.

Search this model on Amazon

As an Amazon Associate, After Warranty may earn from qualifying purchases.

Keep researching

What breaks?

What breaks? · reports

Overheating

Gas Water Heaters (118)

1 months

Government / agencyIndexed Nov 11, 2026Source-linkedVerify source — SaferProducts.gov incident

SaferProducts.gov consumer incident report 20181029-88D8F-2147384747. Severity: Incident, No Injury. Product: Rheem Performance Platinum XG50T12HE40U0 (Gas Water Heater). Incident: I recently installed a Rheem gas water heater to as a replacement for an older heater. I attached the supplied draft vent hood to my existing 4 inch diameter flue. I performed the recommended draft test using a match and found sufficient draft for the operation of the appliance. After allowing the unit to operate overnight, I went to check the water connections for leaks. I observed that the plastic escutcheons and a plastic label on the top of the unit were melted. I contacted Rheem customer support and was instructed to perform the draft test again. Sufficient draft was present. While the Rheem supplied draft hood accepts a 4 inch flue, the opening for the flue gasses is 3 inches. It doesn't appear that this restricts the flow of the gasses, but does appear to reflect enough heat to melt the plastic components on the top of the unit. I've temporarily replaced the Rheem draft hood with one that has a true 4 inch opening and the melting condition has stopped. The CO detector in the basement hasn't activated, so I'm confident that the replacement draft hood is working properly.

UnverifiedEvidence ★★★★☆
View report details

Months until failure

1 months

Repair cost

Not stated

Repaired

Not stated

Manufacturer warranty

Not stated

Extended warranty

Not stated

Support helpful

Not stated

Would recommend

Not stated

AI extraction confidence

84%

Verification status

Unverified

Evidence quality

★★★★☆ (4/5)

Discussion

Compare nearby models

Similar products

Stay ahead of failures

Notify me about this model

Get an email when a new source-linked failure report is published for the Rheem Performance Platinum XG50T12HE40U0.

We only email when a new published report is added for Rheem Performance Platinum XG50T12HE40U0. No spam, unsubscribe by contacting support.

Contribute signal

Had a failure with this model?

Add your experience and help future shoppers understand what happens after the warranty.

Submit your experience